Home > Agriculture > Quizzes > Agricultural Engineering (Water Resources Development and Management) Practice Test Questions
Agricultural Engineering (Water Resources Development and Management) Practice Test Questions
Fast practice, instant feedback. Timer auto-submits when time’s up.
Avg score: 100% Most missed: “A 60 m wide rectangular channel with bed slope 0.03% is flowing at a 1.5 m depth…”
Agricultural engineering, also known as agricultural and biosystems engineering, is the field of study and application of engineering science and designs principles for agriculture purposes, combining the various disciplines of mechanical, civil, electrical, food science, environmental, software, and chemical engineering to improve the efficiency of farms and agribusiness enterprises as well as to ensure sustainability of natural and renewable resources. An agricultural engineer is an engineer with an agriculture background. Agricultural engineers make the engineering designs and plans in an... Show more
Agricultural Engineering (Water Resources Development and Management) Practice Test Questions
Time left 00:00
25 Questions

1. Two canals ‘A’ and ‘B’ are running parallel having ground level at 200 ft and 198 ft respectively. A pipe ‘C’ of 5 feet diameter connects the two canals. The direction of flow between two canals through the pipe would be:
2. From a source of water supply, the septic tank should never be closer than:
3. The height of walls running along the barn length may be:
4. The lifting of a Helicopter is based on:
5. Pollution from crop lands, rural homes, urban streets and from the atmosphere via rain water etc. is the:
6. A rectangular beam 300 mm deep is simply supported over a span of 4 meters. What uniformly distributed load the beam may carry, if the bending stress is not to exceed 120 MPa. Take I = 225 ×106 mm4.
7. The runoff coefficient is measured in:
8. The frictional resistance of a pipe varies approximately with _________________ of the liquid:
9. A flow in which liquid particle has definite path of flow and don’t cross each other is called:
10. The process by which a body of water becomes, either by natural means or by pollution, excessively rich in dissolved nutrients, resulting in extensive algal growth is called:
11. The earthen embankment constructed along both the banks of a river to control flood is known as:
12. According to first law of thermodynamics, the cyclic integral of heat transfers is equal to the cyclic integral of ___________ transfers.
13. A hallow circular steel (E= 30,000 ksi) column, 15 ft long has an inner diameter of 3 inch and outer dia of 4 inch, the slenderness ratio of the column is:
14. A statistical method of analyzing hydrological or other data which uses the observed number of occurrences to predict how often a phenomenon may occur in the future is known as:
15. A record of personal finances is best maintained by using which of the following?
16. Erosion by runoff is to be expected on sloping land under intensive rainfall and insufficient:
17. Hydrometer method is used to determine:
18. For a sandy loam, non-saline soil, the moisture deficit before irrigation was 50 mm. The farmer has to irrigate 0.5 ha (hectares) with a discharge of 28 lps (liter per seconds) at irrigation efficiency of 55%. The time required to irrigate the field is:
19. The geological formation, which yields only insignificant quantity of groundwater, is an:
20. Equal-to, less-than, and greater-than are examples of:
21. The accumulation of maintenance needs being accrued under the normal or routine maintenance program because of paucity of funds and some other reasons is called:
22. In 4-stroke diesel engine, during power stroke, the
23. Farmstead must represent the cropped land area of the farm in the proportion of:
24. A farmer is using a tractor on a hill slope of 1 in 20 with the velocity of 10 km/hr. If weight of tractor is 3000 kg, the horse power of tractor is:
25. If a stream of 135 lps is diverted from a canal but only 100 lps reaches the field. The conveyance efficiency in this case is: