Radio Receivers
Fast practice, instant feedback. Timer auto-submits when time’s up.
Avg score: 22% Most missed: “Which of the following circuits can not demodulate SSB?”
Radio Receivers
Time left 00:00
25 Questions

1. In a broadcast superheterodyne receiver, the
2. In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 25 MHz will be
3. A heterodyne frequency changer is called a
4. A duplexer is a device used to ....
5. We should use ........... to prevent overloading of the IF amplifier in a receiver.
6. In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The rejection ratio at 25 MHz will be '¦'¦'¦
7. The controlled oscillator synthesizer is sometimes preferred over the direct one because
8. Most popular IF for receivers tuning to 540 to 1650 kHz is
9. A transmitter serial current contains
10. What happens, if the intermediate frequency is too high in a radio receiver?
11. Which of the following is the function of radio receiver?
12. A superheterodyne receiver with an IF of 450 kHz is tuned to a signal at 1200 kHz. The image frequency is
13. In a radio receiver with simple AGC
14. The selectivity of most receivers is determined largely by
15. In a broadcast superheterodyne receiver
16. In a ratio detector
17. A receiver has poor IF selectivity. It will therefore also have poor
18. Indicate which of the following circuits could not demodulate SSB:
19. In a radio receiver with simple AGC
20. FM amplifier in a superheterodyne receiver
21. In a ratio detector
22. The frequency generated by each decade in a direct frequency synthesizer is much higher than the frequency shown; this is done to
23. Indicate the false statement in connection with communications receivers.
24. The typical squelch circuit cuts off
25. Neutralization is used in RF amplifiers to