From the following sequences of steps, indicate the proper order you would use to make a single flare on a piece of tubing: 3. From the following sequences of steps, indicate the proper order you would use to make a single flare on a piece of tubing: 1. Place the tube in the proper size hole in the flaring block. 2. Project the end of the tube slightly from the top of the flaring tool, about the thickness of a dime. 3. Slip the fitting nut and sleeve on the tube. 4. Strike the plunger several light blows with a lightweight hammer or mallet and turn the plunger one-half turn after each blow. 5. Tighten the clamp bar securely to prevent slippage. 6. Center the plunger or flaring pin over the tube.