Home > Stock Markets > Quizzes > TREC Home Inspector National Exam: HVAC
TREC Home Inspector National Exam: HVAC
Fast practice, instant feedback. Timer auto-submits when time’s up.
Avg score: 12% Most missed: “Flexible ducting requires _____________________ inch strapping every 4 feet.”
TREC Home Inspector National Exam: HVAC
Time left 00:00
25 Questions

1. A Type B-W gas vent shall terminate at least _____________________ feet in vertical height above the bottom of the wall furnace.

2. return air from a garage

3. Mechanical appliances installed in attics shall have a luminaire controlled by a switch located at the required _____________________ _____________________ and a 120 volt receptacle outlet provided at or near the appliance location.

4. Gas appliance shutoff valves shall be located in the same room as the appliance and not further than _____________________ feet from the appliance.

5. Underground fuel gas piping systems shall be installed a minimum depth of _____________________inches below grade.

6. Confined Space and Combustion Air

7. No AC return air grilles are permitted within _____________________feet of the fireplace.

8. BTU is the abbreviation for _____________________ _____________________ _____________________, which is the quantity of heat required to raise the temperature of 1 pound of water by 1 degree F.

9. The U.S. government has established a minimum rating for furnaces of

10. What are the two major duct categories?

11. Don't test the house heating if the outside temperature is above _____________________°F.

12. Where would you most likely find a Perimeter loop warm air heating system ?

13. Service receptacles for HVAC equipment must be within _____________________ feet of inside and outside units.

14. For gas appliance installations using the two-permanent-openings method for combustible air from the outdoors, one opening shall be within _____________________ inches of the top and one within _____________________inches of the bottom of the space.

15. Openings must be located more than 10 feet measured in any direction from an open combustion chamber or draft hood of another appliance located in the same room or space. - The amount of return air taken from any room or space must not exceed the flow rate of supply air delivered to that room or space. - Return air must not be taken from a closet, bathroom, toilet room, kitchen, garage, mechanical room, boiler room, furnace room, or unconditioned attic.

16. The maximum discharge temperature for ducts of a warm-air heating system is ....

17. Louvers: In calculating the free area of a combustion air opening fitted with louvers, the inspector should note that metal louvers obstruct about ........ of the opening, and wooden louvers obstruct ...... of it.

18. The use of gypsum material (drywall) for the construction of a return air duct system or plenum is allowed, provided that the air temperature does not exceed.......... Gypsum board is a composite material commonly used to build air plenums, shafts, and spaces. Air temperatures greater than 125℉ will, over time, dry out the paper facing material on the drywall and will lead to deterioration of the panel. Drywall can also deteriorate when exposed to moisture or condensation. For this reason, drywall must not be used with evaporative cooling equipment (or swamp coolers).

19. Don't test the AC if the outside air temperature is below _____________________°F.

20. Difference between a perimeter & a plenum duct system?

21. A common deficiency with vent hoods is that they are _____________________.

22. A house heater should be able to maintain a temperature of _____________________°F, measured 3 feet above floors and 2 feet from walls.

23. Disadvantages of Warm-Air Heating Systems

24. concentric cones or pyramids

25. The dryer transition duct must be at least _____________________ feet in length.