Home > Consumer Behavior 101 > Quizzes > HAZWOPER Training All Modules Revision
HAZWOPER Training All Modules Revision
Fast practice, instant feedback. Timer auto-submits when time’s up.
Avg score: 100% Most missed: “______ requires prompt treatment to prevent irreversible damage or death”
HAZWOPER (Hazardous Waste Operations and Emergency Response) is an OSHA standard 29 CFR 1910.120 requiring safety training for workers handling hazardous substances during cleanups, emergency responses, or at treatment/disposal sites. It aims to prevent injury by mandating specialized training (40-hour, 24-hour, 8-hour refresher) and Personal Protective Equipment (PPE). Key Aspects of HAZWOPER: Scope: Applies to cleanup operations, corrective actions at RCRA sites, voluntary cleanups at uncontrolled hazardous waste sites, and emergency response to hazardous substance releases. Training... Show more
HAZWOPER Training All Modules Revision
Time left 00:00
25 Questions

1. Water reactive metals tend to be soft metals that have _____ melting points

2. The primary purpose of a medical surveillance program is to ____

3. _______ is the negative log of the concentration of H+ in solution

4. The ______ outlines what needs to be accomplished and then prescribes procedures to protect the health and safety of the entry team

5. _____: remove or assist victims from the area

6. The appropriate procedures for handling drums depend on the _______

7. Site characterization is done to:

8. ______ are microorganisms such as bacteria or viruses

9. _____ is determined experimentally by measuring face piece seal and exhalation valve leakage

10. OSHA defines _______ as any substance that will spontaneously decompose, polymerize, or self-react under conditions of shock, temperature, or pressure

11. Upon finishing shifts, workers must replace body fluids by drinking ample ____ to prevent dehydration

12. OSHA requires a written program for selection and use of respirators in _____

13. If there is an ignition source present, hydrogen gas will _______

14. Regulators are gas specific and not necessarily _______

15. Flushing must continue for a minimum of ______ to ensure that all the chemical that can possibly be removed is in fact removed

16. The purpose of an ______ is to verify and supplement information from the off-site characterization

17. The hazard most likely to be encountered in incidents involving oxidizers is that the oxidizer ______ combustion

18. Pick the best treatment for heat stress

19. The individual who uses a respirator is required to perform a _____ to ensure that an adequate seal is achieved each time the respirator is put on

20. ______ should be carried out when site hazards are largely unknown or when there is no need to go on site immediately

21. Trench boxes or shields must be approved by a _______

22. Site control zones at a hazardous materials incident are established primarily...

23. Safe distances can only be ______ at the time of an emergency

24. What is the hazard classification for a label/placard that is blue in color?

25. _________ can by stopped by lead