Home > IT Networking > Quizzes > Computer Networks: Switching MCQs
Computer Networks: Switching MCQs
Fast practice, instant feedback. Timer auto-submits when time’s up.
Avg score: 38% Most missed: “Three methods of switching are”
Computer Networks: Switching MCQs
Time left 00:00
25 Questions

1. A switch that connects n inputs to m outputs in a grid, using electronic micro switches at each cross point is called
2. A switched network consists of a series of interlinked nodes, called
3. The routing processor searching for the routing table is called
4. A switch in a datagram network uses a routing table that is based on the
5. Global and local addressing are types of
6. A Virtual-Circuit Network (VCN) is normally implemented in the
7. Time Division Multiplexing inside a switch, is used by
8. Datagram switching is done at the
9. A switch in a datagram network uses a
10. A Circuit-Switched Network is made of a set of switches connected by physical
11. The actual communication in a circuit-switched network requires
12. Which frame completes the entries in the switching tables?
13. The Asynchronous Transfer Mode (ATM) network is an example of
14. The network where there is no resource reservation is called
15. Circuit Switched Networks are used in
16. In a packet-switched network, resources are allocated
17. The identifier that is actually used for data transfer is called the
18. Only one packet for each destination is allowed at each tick; if there is more than one, they wait for the next tick in
19. Virtual-Circuit Networks and datagram networks are the sub categories of
20. Circuit switching takes place at the
21. In Circuit Switching, the resources needs to be reserved during the
22. The phase where the establishment of the channels takes place is
23. Three methods of switching are
24. Iog28 =
25. The term that refers the switch does not keep information about the connection state, is