1. An engine will not start. The technician uses a scan tool and finds DTC (Diagnostic Trouble Code) P0335 (Crankshaft Position Sensor [CKP]) stored. This vehicle has electronic ignition without a distributor. Which of the following is the MOST likely cause?

2. Two technicians are discussing the ECM (engine control module) reprogramming process. Technician A says the first step in the reprogramming procedure is to determine the current software needed. Technician B says in most cases using the factory scan tool or software is needed for reprogramming. Who is right?

3. Which of the following would indicate a closed EGR (Exhaust Gas Recirculation) valve?

4. A vehicle with a no-start concern has been checked with a spark checker and has no spark to the plugs. Technician A says to test for battery voltage at the ignition coil by connecting the red lead of a DMM (Digital Multimeter) to the coil negative terminal and black lead to a good ground. Technician B says with the DMM red lead on the coil negative terminal and the black lead grounded, the voltage should fluctuate while cranking the engine. Who is right?

5. Which I/M (Inspection/Maintenance) test uses a dynamometer that places a "single weight" load on the vehicle?

6. An engine with SFI (sequential fuel injection) has low power. The emission readings on a 5-gas analyzer suggest which of the following causes?

7. The engine cranks but will not start. Which of the following should be checked first?