Home > FBLA > Quizzes > FBLA Networking Concepts Test 5
FBLA Networking Concepts Test 5
Fast practice, instant feedback. Timer auto-submits when time’s up.
Avg score: 37% Most missed: “Which fiber connector uses a twist-type attachment mechanism?”
FBLA Networking Concepts Test 5
Time left 00:00
25 Questions

1. When a computer boots up and tries to obtain an IP address automatically, but does not find a DHCP server, what addressing is used?
2. Which one of the following applications, if running on a server, would most likely require more RAM than the minimum specified by the NOS vendor?
3. The connection-oriented, reliable transport of data takes place at what layer of the OSI model?
4. With respect to structured cabling, a(n) is the location of the cabling and equipment that connects a corporate network to a third-party telecommunications provider.
5. Most NICs in computer workstations today are connected to what type of bus architecture?
6. You must propose a cabling scheme for your company's new location. Several departments are located on the same floor with a maximum distance of 61 meters (200 feet) between departments. You want a relatively easy, low-cost installation with simple connections. Which type of cabling would you propose?
7. A form of ____is used in wireless LANs with an access point.
8. Class ____addresses are reserved for experimental use and cannot be used for address assignment.
9. Twisted pair cable installations are covered by what wiring standard?
10. ___ frames are created for any computers on a network that 'listen' to a shared network address.
11. Which benefit does starting Samba on a UNIX/LINUX server provide?
12. Which network transmission medium is limited to 10 megabits per second and can support cable segments up to a maximum of 100 meters?
13. You are experiencing connection problems with the fiber-optic cables in the 100BaseFX LAN that you administer. What could be the cause of this problem?
14. Which fiber connector uses a twist-type attachment mechanism?
15. One of the most widely used high-speed digital lines is the ____, a DDS technology that uses two two-wire pairs to transmit full-duplex data signals at a maximum rate of 1.544 Mbps.
16. Your company is planning to rebuild its network infrastructure. You are asked to provide a topology that will be scalable and easy to troubleshoot. Which topology should you recommend?
17. To use file level security you should have what file system installed?
18. Twisted pair cabling is commonly terminated with what type of connector:
19. You are assisting your senior technician in extending the Denmarc for a new DSL circuit. Which tool should you use?
20. uses specially shielded, balanced, copper jumper cables.
21. A V.90 modem uses a technique called ____that digitizes analog signals.
22. ___ is a name-to-address resolution protocol that functionally operates at the Session layer of the OSI model.
23. defines Gigabit Ethernet over fiber-optic cable.
24. The job of the to convert bits into signals for outgoing messages and signals into bits for incoming messages.
25. You are the administrator of a network with 250 nodes. You want to implement video conferencing, but your network is performing poorly. Through network analysis software, you determine that the hub is the bottleneck. Which device should you install in place of the hub to alleviate the bottleneck?